Hi, I am trying to use an anulus and a cylinder 2 pipe to form a lens aperture stop, I set both to ABSORB at the material taps. But there are still a lot of rays pass through. I close the anulus or open the anulus, the intensity on the detector is the same. Looks like they are still transparent. Could you tell me how to fix this. Thanks so much
Question
Annulus/cylinder2 pipe absorbing property does not work
If I put the anulus before the paraxial lens, the anulus is transparent. If I put it after the paraxial lens, it is a absorber. Is it some default property of the paraxial lens?
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Need more help?
To Chinese users:
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。