A source diode emits light that goes through a PBS and is then collimated by a paraxial lens. A detector is placed after the lens.
For a fixed position of the paraxial lens, I would like to sweep the focal length and pick the one that minimises the RMS angular radius at the detector. However, after defining a Merit Function, the drop down menu in the Universal 1D plot does not give me access to the focal length of the lens. How can I access this attribute within the Universal 1D plot?
The X Focal Length, and Y Focal Length of a Paraxial Lens object are the parameters 3, and 4 respectively. If you don’t know how to check what parameter is a given column in the LDE or NCE, create a dummy surface or object, and look at the column header in the corresponding cell.
When clicking a cell from the Paraxial Lens, you see the actual header for the column of that object.When clicking on the corresponding cell of a Null Object, you get to see the corresponding parameter (Par) number.
You should then be able to setup your Universal Plot like so:
The X Focal Length, and Y Focal Length of a Paraxial Lens object are the parameters 3, and 4 respectively. If you don’t know how to check what parameter is a given column in the LDE or NCE, create a dummy surface or object, and look at the column header in the corresponding cell.
When clicking a cell from the Paraxial Lens, you see the actual header for the column of that object.When clicking on the corresponding cell of a Null Object, you get to see the corresponding parameter (Par) number.
You should then be able to setup your Universal Plot like so:
David is quite right. I would also like to offer two additional comments.
If you wish to control both focal lengths with one value, then you could set the other focal length as a pickup which gets its value from the first. For example, you could set the y focal length to pickup the x focal length value and then control the x focal length to control both.
Also, to determine the best focal length you could use optimization. You can use the Optimization Wizard to create a merit function that targets zero RMS angular radius on the detector. Then make the focal length variable and optimize. In the attached file, the front and back radii of a standard lens are independent and optimized to collimate a source two angle. The file is attached as a zar in a zip.
We use 3 different kinds of cookies. You can choose which cookies you want to accept. We need basic cookies to make this site work, therefore these are the minimum you can select. Learn more about our cookies.
