I tried to change surface setting in spot diagram by ZOSAPI MATLAB and get spot position info by the following commands in MATLAB:
spot.ApplyAndWaitForCompletion();
spot_results = spot.GetResults();
spot_results.SpotData.GetReferenceCoordinate_X_For (2,1)
spot_results.SpotData.GetReferenceCoordinate_Y_For (2,1)
Which command should I use to fulfil this task??
Best answer by David.Nguyen
Hi Shih-Heng,
Standard spot diagram has its settings implemented in the ZOS-API.
The lines of code you need are
MySettings = spot.GetSettings(); MySettings.Surface.SetSurfaceNumber(5)
Those should be before you use ApplyAndWaitForCompletion, and after you've created the analysis. Replace the number 5 by whatever surface you wish to apply.
Hope this helps.
Take care,
David
+2Hi Shih-Heng,
Standard spot diagram has its settings implemented in the ZOS-API.
The lines of code you need are
MySettings = spot.GetSettings(); MySettings.Surface.SetSurfaceNumber(5)
Those should be before you use ApplyAndWaitForCompletion, and after you've created the analysis. Replace the number 5 by whatever surface you wish to apply.
Hope this helps.
Take care,
David
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。