Hello everyone !
After I finished the design with OpticStudio, I wanted to leave some allowance for seci diameter, but I found that the column of mechanical seci diameter was gray and could not be edited. May I ask how to solve this situation?
thanks !
like this:
Best answer by Andrey.Pravdivtsev
What type of license do you have? If I correct it works for Professional and Premium only.
What type of license do you have? If I correct it works for Professional and Premium only.
+1Hi
Yes~ Andrey is correct. It should be caused by the license version. Chip Zone and Mechanical Semi-Diameter. Both parameters are available in the Professional and Premium editions only.
Sean
Thank you for your help. It seems to be the software version.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。
