Hello, I have a model as shown below. How can I shift the existing coordinate break origin to the new location and reset it back to original location?
Is my ask equivalent to the new Zemax MPVT operand?

Thanks - Asuku
Hello, I have a model as shown below. How can I shift the existing coordinate break origin to the new location and reset it back to original location?
Is my ask equivalent to the new Zemax MPVT operand?
Thanks - Asuku
Best answer by Asuku
I figured it out (followed this KB). It was quite unclear to me if we can apply the same technique as described in this KB on a Coordinate Break surface. I tried it out and it works.
I will mark this as Solved. Thanks!
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.