Hi all,
I am currently doing an optics project with some mechanical simulations.
We are trying to simulate the surface deformation with mechanical design software.
Then input the data to ZEMAX.
If I have a sag data like the attached,
could I input these data to get the surface in ZEMAX? Including radius of curvature and aspherical coefficients.
Thank you,
Raymond
Best answer by Allie
Hi Raymond,
Andrey is correct - the Grid Sag will let you input that data directly into OpticStudio as a surface. I have written a series of Knowledgebase articles about the Grid Sag surface. I think you will find the first two articles helpful:
Let us know if you have any other questions about this!
Best,
Allie
+2Hi Raymond,
Andrey is correct - the Grid Sag will let you input that data directly into OpticStudio as a surface. I have written a series of Knowledgebase articles about the Grid Sag surface. I think you will find the first two articles helpful:
Let us know if you have any other questions about this!
Best,
Allie
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。
