Good morning,
I imported an LED source with the .DAT file, is it possible to analyse the angular distibution?
Below is the angular distribution taken from the datasheet
Solved
Angular distribution
Best answer by David
Hi Daniel,
You can do this using a Detector Polar with the Detector Viewer set to Show As: Directivity Half. Unless you can trace a lot of rays, like 1E6, you will need to adjust the viewer smoothing to reduce noise. The Detector Polar is set to Radial Size larger that the dimensions of the extended source so it captures all the rays. In the case below, I limited the detector to a 90 degree half-angle.
+4Hi Daniel,
You can do this using a Detector Polar with the Detector Viewer set to Show As: Directivity Half. Unless you can trace a lot of rays, like 1E6, you will need to adjust the viewer smoothing to reduce noise. The Detector Polar is set to Radial Size larger that the dimensions of the extended source so it captures all the rays. In the case below, I limited the detector to a 90 degree half-angle.
Hi David,
thank you so much!
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Need more help?
To Chinese users:
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。