Not sure if this topic was discussed before, but I haven’t found it yet.
Sometimes I need to export lenses to CAD file (STEP or X_T) including ray bundles for each object field. What is proper setting for having rays that can be viewed in program like Solidworks?
For example I tried the setting below, but this STEP file didn’t display field cone rays in SW.
Regards
JS
+2
There used to be a knowledge base article about it, but I can’t find it anymore. I would have thought it would be in this article, but it only has Autodesk and Creo:
However, this was previously discussed in this community, such as in the following posts:
There’s also a Youtube video from Opto-Mechademic that shows how to do it:
https://www.youtube.com/watch?v=WLrNWfvVgOE
I hope this helps and take care,
David
You are correct.
I remember clearly there is a section on how to export rays to Solidworks in this KB article.
Remove this section may due to competitor relation between Ansys ,Dassault even with Simens.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。
