i am desing a intefreomere by modulating the phase of the incident light so it splits the beam into two. I could design the phase mask using grid phase surface in zemax with sequential model. since in sequential mode no detector view is available i could not see any fringe formation. Instead, i could see only two overlaped beams.
Is their any possibility to get a detector square view in sequential mode? or
How to import grid phase to non sequentila mode?
+2I don’t have an answer, but this was asked again more recently:
Take care,
David
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。