Dear Sir/Madam,
I am getting the geometric error when I am running the Ray Trace Tool. Light is going from fiber (illuminating fiber) to Mirror, and after reflection form mirror it is again going back to same fiber(illuminating fiber), I think this is creating error while ray tracing, Is it? I want reflected light in receiving fiber only.
I am attaching the screenshot for your reference.
How to overcome this error, please help me out, or else Can I gnore this error?
Thank you.
Best answer by Alissa Wilczynski
Geometry errors are actually not uncommon or unexpected… you just have to verify that they’re not a cause for concern in your system. This 2-part article will walk you through what to do: How to locate geometry errors: part I – Knowledgebase (zemax.com)
The general rule of thumb that we use is that errors and losses of 2% or less are acceptable, but more than that needs to be fixed. Of course, you may have your own requirements in this regard, but most systems will generate a geometry error every once in a while.
+3Geometry errors are actually not uncommon or unexpected… you just have to verify that they’re not a cause for concern in your system. This 2-part article will walk you through what to do: How to locate geometry errors: part I – Knowledgebase (zemax.com)
The general rule of thumb that we use is that errors and losses of 2% or less are acceptable, but more than that needs to be fixed. Of course, you may have your own requirements in this regard, but most systems will generate a geometry error every once in a while.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。
