Hi, I am writing a macro to modify some surface properties and I can't figure out how to define a pickup...
Here is what I am trying to do:
SRFn (actually a coordinate break) : I use SETVAR to set the parameter #1 to variable
SRFn+3 (I want to make it a coordinate break return): I would like to set parameter #1 of this srf by pickup the one of SRFn but I can't find the right ZPL keyword to do that.
Any help is welcome.
+2Hi Renaud,
I hope this macro excerpt can help:
# Surface where the solve is set pickup_surface = 2 # Surface from which the solve is picked up from_surface = 1 # Solve code for a [Thickness Pickup] # (Parameter pickup code is 'PP_p' where p is the parameter number) thickness_pickup$ = 'TP' # Solve codes can be found in the Help File under: # The Programming Tab > About the ZPL > KEYWORDS (about the zpl) > SOLVETYPE # Scale factor scale_factor = 1.25 # Offset offset = 2.75 # Conic column (Parameter 1-12 columns are encoded with numbers 5-17 respectively) conic = 3 # The columns are encoded as specified under: # The Programming Tab > About the ZPL > Using ZPL Macro Solves > Integer Codes for Column Numbers # Setup the pickup solve SOLVETYPE pickup_surface, thickness_pickup$, from_surface, scale_factor, offset, conic
Take care,
David
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。
