Hi, I want to do a loop to get a lot of MTF curves. How do I do with GETMTF?
I know how to run it in a single time, but if I want to change object distance every time and rerun the GETMTF,
how should I do the loop? How to set object distance at ZPL macro?
Thanks a lot.
Best answer by Berta.Bernad
Hi Weihua,
You can set object distance (and another properties of surfaces) with the keywords SETSURFACEPROPERTY/SURP
The Programming Tab > About the ZPL > KEYWORDS (about the zpl) > SETSURFACEPROPERTY, SURP
And then use a FOR loop to change it. The sintax for FOR loops is the following:
FOR variable, start_value, stop_value, increment
(commands)
NEXT
So something like this will change the object distance from 10 to 100 with an increment of 10 and retrieve the MTF:
+2Hi Weihua,
You can set object distance (and another properties of surfaces) with the keywords SETSURFACEPROPERTY/SURP
The Programming Tab > About the ZPL > KEYWORDS (about the zpl) > SETSURFACEPROPERTY, SURP
And then use a FOR loop to change it. The sintax for FOR loops is the following:
FOR variable, start_value, stop_value, increment
(commands)
NEXT
So something like this will change the object distance from 10 to 100 with an increment of 10 and retrieve the MTF:
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。