I am trying to interface optics builder with Solidworks. I have installed both but when I try to add the optics builder add-in to solidworks, I am getting the message 'Unable to run optics builder'. When I run the zemax troubleshooter i get the following output (see image). How should I proceed?
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。