Hello,
On the sequential mode of Zemax, the source is represented by just one wavelength. I would like to know if it is possible to see the phase map for a source with a spectral width with the sequential mode of Zemax ?
If it is not possible directly, maybe I can save the value of the graph RMS vs Wavelength for my spectral range and after i will manipulate these data to add a weight on each wavelength ?
Thanks for your answers
Best answer by Mark.Nicholson
Nope: I mean the Universal Plot 
It’s a special plot type that lets you define the x and y axes. Put wavelength on the X axis and something like OPTH on the y and you should have what you want.
+3Try a Universal plot where you scan the wavelength over whatever range while plotting the operant that corresponds to your y-axis variable
Thank you for your answer Mark !
By Universal plot, you mean the RMS Vs Wavelength ?
Because my problem in this case is that there is no notion of the light spectral distribution. I mean, if my source is centered at 625nm with a FWMH of 10nm, the contribution of 625nm in the phase map will be higher than the contribution of 620nm for example. And this is what I want to see : the final phase map obtained thanks to all the wavelength present in my light source but with the good contribution.
+3Nope: I mean the Universal Plot It’s a special plot type that lets you define the x and y axes. Put wavelength on the X axis and something like OPTH on the y and you should have what you want.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。