Say my laser source is 1300 +/-10nm, with normal distribution 3 sigma, which operant to use to include it in the tolerance editor?
Thanks.
Best answer by David.Nguyen
View originalSay my laser source is 1300 +/-10nm, with normal distribution 3 sigma, which operant to use to include it in the tolerance editor?
Thanks.
Best answer by David.Nguyen
View originalHello
I’m not sure that’s what you’re asking, but here’s what I’d do.
If you run some Monte Carlo runs, this is what you’d get:
I hope this helps.
Take care,
David
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.