Hello. I am trying to model a Angle Cleaved fiber source that emits beam. I would like to show the exit beam is offset at 4° from the optical fiber mechanical axis. How can I model this in SEQ mode? Essentially, I want to model something like shown below in Zemax Sequential mode.
PS: I am referencing this KB article to model a Angle Cleaved fiber on the receiving side.
I like to use the Tilted surface:
By making the object surface thickness very small, say ~1 um or less, you can simulate an angled-facet fiber source:
PS: I have a follow up question on how to pivot Surf0 and Surf1 as a single entity (such as a lens) at an arbitrary point in Z so that the exit ray from Surf2 is 0°. I imagine using READ operand but I am not clear on how to pivot first 2 surfaces. I will post this as a new question on the forum.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。