Hi Zemaxers
I am learning to do an image simulation in non-sequential mode.
but not sure whether I am right, could you give me some advice?
what I did
1) set the slide object after the source
2) use detector rectangle to analysis
3) ray tracing
3) show the radiant intensity in detector viewer
My question
1) is the step above all right?
2) the result the detector viewer shows includes aberrations?
Thank you in advance!
This is pretty much OK, except I see only parallel rays from your source, try using Source Diode for example to add angles according to your NA
Oran Thank you!
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
Do not provide any information or data that is restricted by applicable law, including by the People’s Republic of China’s Cybersecurity and Data Security Laws ( e.g., Important Data, National Core Data, etc.).
不要提供任何受适用法律，包括中华人民共和国的网络安全和数据安全法限制的信息或数据（如重要数据、国家核心数据等）。