Hi everyone, I need your kindness help for some problems that I had during analysis using physical optic propagation. I don’t know whether my system is good or not, but I believe can analyze or optimize my system to be better.
I had 3 questions that I would like to ask. I use prop report in POP to see each of the surface in my system.
- What mean by using outside to outside propagator. Is I need to check anything like I tick the use angular spectrum so that my surface become using inside to inside propagator? Or is there another way to solve it. Or I just have to ignore it.
- Sampling is too low. I use resample after refraction so that I can increase the sampling. Are there any ways so that I can keep the original sampling without increasing it?
- Inadequate guard band detected. My system shows this warning, and I did not know the ways to solve this problem. Is there any ways that I can use in order to solve it?
I am sorry for asking that kinds of problems because I am a beginner in using Zemax. If anyone can help me in order to solve the problems, I really appreciate for your kindness.
Thank you.